Novy 2961 Operating And Installation Instructions Download

Page: 49 / 76

Installation instructions

Before installation

Check that the input voltage

indicated on the

characteristics plate is the same as the voltage of
the power outlet you are going to use.

Open the drawer and

take out all the

accessories

and remove the packing material.

Attention!

The front surface of the warming

drawer may be wrapped in a

protective film

Before using the warming drawer for the first time,
remove this film carefully.

Make sure that the warming drawer is not
damaged in any way.

Check that the drawer

opens and closes correctly. If you find any
damage, contact the Technical Assistance
Service.

Attention: the power socket should be easily
accessible after the warming drawer has been
installed.

The  warming  drawer  should  only  be  built-in  in
combination  with  those  appliances  indicated  by
the  manufacturer.

If it is fitted in combination

with  other  appliances,  the  guarantee  is  no
longer  valid  since  it  is  impossible  to
guarantee  that  the  warming  drawer  will  work
correctly.

Installation

To  build-in  the  warming  drawer  in  combination
with  another  appliance  there  must  be  a  fixed,
interim  shelf  in  the  housing  unit  to  support  the
weight of both appliances.

The appliance to be combined with the warming
drawer will be placed directly on the latter without
any need to have a separating shelf.

To build-in the appliance which is combined with
the warming drawer, follow the instructions set out
in the respective instructions and fitting booklet.

The relevant installation dimensions are indicated
in mm

in the diagrams shown at the end of this

booklet

. Proceed as follows:

1. Place the warming drawer on the shelf and

slide it towards the interior of the niche in
such a way that it is centred and completely
lined up with the front of the unit.

2. Check that the warming drawer

’s frame is

properly levelled and is sitting evenly on the
shelf.

3. Open the drawer and fix the warming drawer

to the sides of the unit using the two screws
provided.

Electrical Connection

The  warming  drawer  is  equipped  with  a  power
cable  and  plug  for  single  phase  current.  We
advise  that  the

plug is connected to a socket

that is easily accessible after installation.

If the warming drawer is to be installed on a
permanent basis

it should be installed by a

qualified technician. In such a case, the appliance
should be connected to a circuit with an all-pole
circuit breaker with a minimum separation of 3
mm between contacts.

The data necessary for the electrical connection
are

described on

the warming drawer’s

characteristics plate

and these must be

compatible with those of the power outlet you are
going to use.

WARNING: THE WARMING DRAWER MUST
BE CONNECTED TO EARTH.

The manufacturer and retailers do not accept
responsibility

for any damage that may be

caused to people, animals or property if these
installation instructions are not observed.