EN 19
determined. This may be, for example, that the
contents of the pan have caught fire, the motor
fan is blocked or an object is (partly) closing off
the exhaust opening.
Illumination
Press key
④
to switch the lighting on or off. The
LED lighting has a soft on/soft off mode, which
means that the lighting will evenly go on and off.
When switching on the lighting, this will always
light up with full power and it can also be used
when the fan is off.
Recirculation (option)
If recirculation has been chosen, this is to be pro-
grammed one time. This programming activates
the cleaning indication of the Monoblock recircu-
lation filter and changes the switch-off delay time.
Programme (do the programming with the mo-
tor switched off):
Simultaneously press the + and the – keys for 5
seconds until the red LED flashes 5 times. The fol-
lowing functions have now been enabled:
• The run-out time has been set to 30 minutes
(instead of the default 10 minutes). Make use of
the 30 minutes run-out time.
• The cleaning indicator for the Monoblock re-
circulation filter has been set to 200 operating
hours.
• The red LED will light up after 200 operating
hours. This indicates that the Monoblock recir-
culation filter needs cleaning
Deactivate the programming (do the deactivate
programming with the motor turned on):
Simultaneously press + and – for 5 sec. until the
third green LED flashes 3 times. Attention! This is
not recommended for a cooker hood with recir-
culation.
Maintenance
Grease filter
The cooker hood contains 1 or 2 metal grease fil-
ters, dependent on the type number.
Grease filter indication:
--------------------------------------------------------
Indication: 4 flashing LEDs
--------------------------------------------------------
After 20 cooking hours, the 4 LEDs will start to
blink during 5 minutes, this indicates that the
grease filter has to be cleaned. When replacing
the cleaned filter, you have to reset the hood by
pushing the – button during 5 seconds . If you
don’t reset, the LED lights will continu blinking.We
advise you to clean your filter twice a month for an
optimal operation.
Access to the filter
Remove the grease filters by pulling down the
stainless steel hinged lower cover plate at the
front side, which covers the grease filters. Pull the
two metal grease filters down by the little hook.
Cleaning the filter:
• in the dishwasher
• manually: in a hot solution of water and a liquid
detergent. Rince and allow to dry completely
Important! The previous instructions need to be
followed. If not an increased fire hazard may oc-
cur.
Recirculation (option)
If you have chosen for recirculation, please follow
the instructions below.
Cleaning indication:
--------------------------------------------------------
Indication: red LED lights up
--------------------------------------------------------
The red LED will light up after 200 working hours
(time to regenerate the Monoblock recirculation
filter). The recirculation filter is to be found behind
the grease filter.
Remove the Monoblock recirculation filter:
• Open the bottom plate with both hands and
remove the aluminium grease filter from the
hood.
• The Monoblock recirculation filter is found in
its opening in the cooker hood. Remove it from
the cooker hood.
Regenerate the Monoblock recirculation filter:
• The Monoblock can be regenerated up to 12
times. This is done in the oven.
• Place the filter in the oven for 1 hour at 120°C.
Provide sufficient fresh air in the room where
the oven has been placed, as smells can be
released. Smells can be released when baking
certain kinds of fish. In this case it is best to im-
mediately regenerate the filter in the oven.