EN 8
GENERAL INFORMATION
General
Read these instructions carefully before installing and commissioning the product. It is recommended to have
one or more qualified persons carry out the installation.
Important before mounting
Observe the following mounting tips before starting the mounting activities:
• Remove the power supply from the hood
InTouch
With InTouch you can operate your Novy hood from the Novy induction hotplate. You control the hood
through the induction hotplate by means of an RF signal. A broad range of Novy induction hotplates has been
provided with InTouch.
MOUNTING
Mount the circuit board
This installation kit includes a remote control and a circuit board. The circuit board is to be mounted in the
hood as a replacement of the current circuit board in the hood. The location of the circuit board depends on
the type number of your hood. It is recommended to mount this new circuit board before mounting the hood.
If necessary, you can contact Novy for information about the location of the circuit board in your hood.
Remote control
The remote control has been pre-programmed and it is ready for use. You can operate the hood with the
remote control as soon as the circuit board has been mounted and connected in the hood.
Only when the remote control needs to be reprogrammed (interaction with other controls)act as in the
following.
Determine the code used:
Simultaneously press on/off + the key with the sun. The lamp flashes as well as the selected code (there are
10 code options in total).
