This signal can be used as a modulation signal for the oscillators, or the joystick.
When the « audio » is selected as a Gate mode, a GATE is trigger when the audio left signal
is loud.
External CV
1 analog input (-6v/6V) and an external GATE IN (0/5V) are available using 3.5 mono jack,
compatible with most modular setup.
MIDI
You can also control your synthesizer with a MIDI cable : using a keyboard to play notes, or
the pitch bend or modulation wheel to modulate the sound. Connect an external sequencer, a
computer etc. The informations used are :
•
Note on / note off, channel 1
•
pitch bend : When receiving a pitch bend information, the CV input is disconnected
from the analog input and connected to this midi data. This data are received only
from channel 1.
•
Program change (from 1 to 10, on Channel 1) load one of the memory.
•
You can also control all fader in midi. Midi data are added to fader value to control the
corresponding parameter. All MIDI data can be send using 7 bits (1 CC), or 14 bits
(using 2 CC). This CC should be send on MIDI Channel 2.
Here is a map of MIDI CC number :
For 14 bit MIDI, use CC x (MSB) and CC x+32 (LSB), always send MSB after the LSB.
5/9
