I don’t have sound, what is the problem?
•
The VOL fader is too low.
•
The VCO frequency is to low.
•
The VCO Waveform selector is on “IN Left” or “IN Right”, and no external signal is
connected.
•
The VCF cutoff frequency is too low/high (depending on the filter type).
•
The ADSR sustain is too low.
•
The ADSR attack is too high (you need a long GATE in order to have a sound).
•
The keyboard is on MENU mode (no GATE signal is generated).
•
The GATE mode is on AUDIO and the external audio is not above the threshold (no
GATE signal is generated).
•
The VCA/MIX MOD fader is configured as VCA modulation, and the modulation signal
and fader are too high.
•
The Delay audio effect WET fader is too high (no sound is feed to the delay).
Resetting your synth
If you want to perform a factory reset of your synth, you should press the “load” switch when
switching the synth on. This will erase all memory and current option.
No modulation patch
There is no way to unplug a modulation : you can only replace it with an other one. In order to
have a basic “patch”, you need to turn the modulation faders to zero.
Here is a fader configuration that produce a very basic sound :
16/17
