Step 21 - Center the pilot chute on the stiffener base over the S folded bridle.
cated at the cap of the pilot
hute. Insert temporary packing pins.
m flap grommet and re-insert temporary pin.
e grommets and secure
ith temporary packing pins. Repeat for other side flap.
tep 25 - Dress up the canopy at the top of the container. All canopy fabric should be below the top edge of the
ack tray and above the stiffener base plate / short divider flaps.
mets, insert ripcord pins. Carefully remove pull
p cords as to avoid burn damage to closing loops.
Record the inspection and repack in Log and on
arachute packing data card.
p by pulling pocket over end of stiffener on inner top flap.
Step 22 - Compress the pilot chute and thread pull up cords through the tabs lo
c
Step 23 - Run pull up cord through botto
Step 24 - Closing either left or right side flap first, insert pull up cords through respectiv
w
S
p
Step 26 - Run pull up cords through the top flap's respective grom
u
Step 27 - Apply safety tie thread to end pin and seal.
p
Step 28 - Close the outer top fla
Emergency Parachute Manual P/N 81101-2P (Revised May 2004)
- 19 -