5
Now, looking through the finder
scope and using the six alignment
thumbscrews, center the object on
the intersection of the crosshairs of
the finder scope. In future, check
the coalignment of the telescope
and the finder scope prior to obser-
vations.
Place the switch of the power
supply in the “0” position.
Connect the power supply 2V
output with the mount socket using
the power cord.
Plug in the power supply into the
220/0 V AC power outlet.
Place the switch of the power
supply in the “l” position. The LED
light on the power supply should
turn on.
Connect hand controller to the mount
with the special cutoff point (1).
POWEr SUPPly AND HAND CONtrOllEr
Warning!
Always connect power supply to the mount using the power cord
with power supply disconnected from the power outlet.
Use only original manufacturer’s power supply fuse or analogue
(consult your dealer).
Always disconnect all the power, if replacing the power supply
fuse.