6
P
ress one of the speed buttons (1)
to start the clock drive. The LED
light on the hand controller should
turn on (2). Push the same button
again to stop the clock drive.
Press one of the two speed
correction buttons (3) while clock
drive is working, if necessary. The
LED light on the hand controller
should blink (2) while button is
pressed down.
For mount mT-3S-2D launch the
clock drive by pushing the button
(2), at the same time the LED ()
must light up. The drive switches off
with pushing the button again.
To correct the speed of monitoring
by two axes, push and hold one
of the corresponding buttons (3)
with continuously working drive,
at the same time the one of LED
of correcting speed (5) must blink.
Choose the correct speed (0.5; 1;
4; 6) with the button (4).
If the telescope is used in the
Southern hemisphere, the direction
of the clock drive rotation must
be changed.
For mT-3S (mT-3S-2D) mount open
the hand controller cover and place
the inside switch with «N/S» (North/
South) markings in the required
position.