INST6210 – 4/09
Installation / Operation / Maintenance
Sentinel Benchtop Ionizing Blower
Model 6210
Overview
The Sentinel Benchtop Ionizer utilizes DC high voltage to
generate balanced ionized airflow to eliminate static charges
on surfaces. The Ionizer can be placed at one end of the
workbench, wall or shelf mounted, and directed at the target
or area to be neutralized. The target’s neutralization time
will be optimal when placed 12” to 48” directly in front of
the Ionizer and will increase as the distance increases.
General Guidelines
•
Keep water, oil, contamination and any fluids away
from the Ionizer at all times.
•
Keep the Ionizer clean inside and out for optimal per-
formance.
CAUTION: DISCONNECT THE IONIZER FROM
POWER BEFORE PERFORMING ANY MAINTE-
NANCE, INSPECTION OR CLEANING TO AVOID
AN ELECTRICAL SHOCK HAZARD AND TO PRE-
VENT DAMAGE TO THE IONIZER.
Contents
Remove the Ionizer from the carton and inspect for damage.
Included with the Ionizer should be:
•
One (1) Sentinel Benchtop Ionizing Blower with Stand
and adjustment knobs installed.
•
One (1) Detachable IEC Power cord (US 115V or 230V,
UK or Euro; must be specified at time of order).
•
One (1) Round foam air filter with (1)
¾
” round hook
fastener dot.
•
This Installation, operation, and maintenance instruc-
tions sheet.
Installation
Locate the Ionizer 12” to 48” from the target to be neutral-
ized for optimal performance, making sure that the airflow
will not be restricted. The Ionizer comes with a stand so that
it can be positioned on a flat surface, aimed at the target and
locked via adjustment knobs. It can also be wall or
shelf mounted to keep valuable bench space free for other
purposes and equipment. A working electrical outlet within
reach of the 6’ long detachable cord that is supplied with the
Ionizer will be required. The outlet must be a properly in-
stalled and grounded 3-prong outlet with supplied voltage to
match the Ionizer being installed. If one is not present, con-
sider relocating the Ionizer to be within reach of an outlet or
having an electrical outlet installed near the Ionizer. Be sure
the ON/OFF switch, located on the front of the Ionizer, is in
the “OFF” position. Plug the power cord into the back of the
Ionizer and then into the appropriate AC power source.
IMPORTANT NOTE:
Before powering up the Ionizer,
verify that the AC outlet is properly grounded and that the
supplied line voltage matches the electrical specification on
the label at the bottom of the Sentinel Benchtop Ionizer.
Plugging the Ionizer into an outlet with the incorrect voltage
may damage the Ionizer and will void any warranty cover-
age. The Ionizer must have a good ground to maintain
proper balance.
