Remove the end programming cap with the NRG Automation label to reveal the
programming panel.
Programming
LED’s
Programming the OPEN and CLOSE limits and FORCE learning.
Step 1. Open Limit:
1. Press P button for 5 seconds - LED’s 1, 2 & 3 will illuminate, then release the P button
2. Press + button once. LED1 will flash
3. Press and hold + button to open the door keeping it pressed until the desired OPEN
position is reached before releasing the + button.
4. Press P button to save OPEN limit position , LED 1 will go out and LED 2 will flash to enter
CLOSE limit setting.
Step 2. Close Limit:
1. Press and hold
-
button to close the door to the desired close position before releasing.
2. Press P button to save the DOWN limit position.
3. LED 2 will go out, LED 3 will flash to enter FORCE learning program.
Step 3. Force Learning
1. Press + button and the door will open automatically to the OPEN limit.
2. Press
-
button and the door will close to the CLOSE limit position.
3. Press P button to save this setting, LED 3 will go out, courtesy light will come on.
4. The reversing force is automatically set.
Installing the Boom
Programming Motor Limits & Force
12
3
S
P
+
-
