NRG USER MANUAL
SymphoniePLUS3 User Guide
SymphoniePLUS3_DataLogger_Manual
Rev. 17
support@nrgsystems.com | Page 138
31 December 2018
DIAL_FAILED_ERR
25102
Modem can’t connect to network. Satellite down and therefore
unavailable; incorrect ISP phone number programmed into iPack;
inadequate antenna signal strength.
PATCH_NOT_APPL_ERR
25103
Data in patch file could not be validated and therefore patch was not
applied.
IPACK_LOW_BAT_ERR
25104
iPack 12V batteries below 10.5 volts; iPack will not attempt call under this
condition.
PATCH_APPLY_EVT
25105
iPack has successfully applied a sensor patch or iPack configuration patch
at indicated date and time.
UPDATE_APPLY_EVT
25106
iPack has successfully applied a firmware update at indicated date and
time.
START_CALL_EVT
25107
iPack has initiated a call.
CALL_SUCCESS_EVT
25108
Normal successful call (you will see one of these events per day on daily call
schedule).
CALL_FAILED_EVT
25109
Call failed due to lack of antenna signal strength, proper phone account
setup, modem registration problem, etc. Other event(s) in Event Log just
prior to this message will indicate failure source.
GPS_SET_EVT
25110
Adequate satellites acquired to update GPS coordinates in the logger (you
will see one of these events per day on daily call schedule).
IPACK_DEAD_BAT_ERR
25111
iPack 12V batteries below 9.6 volts; iPack will not power up modem or
attempt call under this condition. “IPack busy or not present” message will
be displayed soon after this event is logged.
CALL_NOW_EVT
25112
Operator initiated a “Call Now” from the logger’s keypad.
CALL_SCHED_EVT
25113
Normal scheduled call (you will see one of these events per day on daily
call schedule).
CALL_BOOT_EVT
25114
Call was initiated following a complete power loss by the logger.
PATCH_NOT_APPL_ERR
25115
Patch file contents (attachment) do not appear to be a patch file.
BOOT_EVT
25117
iPackACCESS rebooted.
NO_LINK_ERR
25118
iPackACCESS Ethernet cable unplugged.