NRG USER MANUAL
SymphoniePLUS3 User Guide
SymphoniePLUS3_DataLogger_Manual
Rev. 17
support@nrgsystems.com | Page 88
31 December 2018
Before Leaving the Site
1.
Check sensor readings to assess sensor condition. Readings that vary widely with expected norms
may indicate a faulty connection. Press [Home][1], then [Up] or [Down] to scroll through the
sensors.
2.
Check all sensor cables, making sure they are firmly attached to the tower.
3.
Check the batteries and clock. Note battery condition. Press [Home][2][1].
4.
Confirm that the SD has been installed and formatted.
5.
Review the time and date settings, and the next call scheduled (remember the clock is set to
Standard time).
6.
Remove the desiccant pack from its plastic bag, and clip it under the gray clip in the logger’s door.
7.
Install the battery cover to securely hold the D-cells and the SCMs. Tighten the thumbscrews by
hand only (do not over-tighten or use tools).
8.
Close the logger’s door, and secure both latches.
9.
Check that the wiring panel is secured to the logger.
10.
Close, latch and lock the shelter box.