SymphoniePRO User Manual
Rev. 8
support@nrgsystems.com | Page 72
11 January 2018
Additional power may be required depending on number and type of sensors. External power terminals are
available on the iPack for this purpose.
Note - Please review the following table to verify correct connections.
Connection Point
Do
Do NOT
Functional Notes
PV Terminals
Do…connect PV panels, DC
power sources between 14 and
28 V DC
Do NOT…connect power
sources in excess of 28 V DC,
including large PV panels
The PV terminals will charge the
iPackGPS’s internal battery; the
PV terminals will NOT charge an
external battery.
External Battery Terminals
Do…connect 12 V battery
and/or external charge
controller up to 14.3 V DC
Do NOT…connect PV panel or
power sources in excess of 14.3
V DC
The external battery terminals
are an input only, an external
battery will NOT be charged
from the iPackGPS through
these terminals nor will the
internal iPackGPS battery.
Grounding Post
Do…connect to wiring panel
grounding post.
Do NOT…leave disconnected or
connect other wires such as
shields.
This terminal will help provide
protection from electrostatic
discharge for the iPackGPS and
logger.
4.5 SENSOR CONNECTIONS
When using the SymphoniePRO-26 wiring panel, it is recommended that
you first install the wiring panel in the shelter box and connect the
sensor wires before installing the SymphoniePRO and iPack. The wiring
panel is mounted to the shelter box by inserting the shelter box’s 4
lowest mounting screws through the holes in the wiring panel bracket,
sliding it to the left, and then tightening the screws to secure it.
Caution
Make sure that the wiring panel’s ground wire is connected to the
earth ground rod before connecting sensor wires! The earth ground
wire should be trimmed to the required length to reach the ground
rod, and excess wire should not be rolled up or coiled.
When using the SymphoniePRO-16
wiring panel, it will be easier to
connect the sensor wires to the
wiring panel before plugging the
wiring panel onto the logger.
Summary of Contents for SymphoniePRO
