Chapter 8. Setup
50
Event Notification
The Event Notification section is divided into three sections: SMTP Settings;
SNMP Trap Receivers; and Syslog Server. Each section is described below.
Note:
SMTP communications are supported on Port 25.
SMTP Settings
To have the eco PDU device email reports from the SMTP server to you, do
the following:
1. Enable the
Enable report from the following SMTP server
, and key in the
IP address of your SMTP server.
2. If your server requires authentication, put a check in the
My server
requires authentication
checkbox.
3. Key in the appropriate account information in the
Account Name
,
Password
, and
From
fields.
Note:
Only one email address is allowed in the
From
fields, and it cannot
exceed 64 characters.)
4. Key in the email address (addresses) of where you want the event reports
sent to in the
To
field.
Note:
If you are sending the report to more than one email address,
separate the addresses with a semicolon or comma, depending on
the specified mail server. The total cannot exceed 256 characters.
Summary of Contents for eco PDU PE series
Page 21: ...Chapter 1 Introduction 12 PE8121kJ 1 2 3 4 PE8121kJ 1 5 5 5 1 ...
Page 25: ...Chapter 1 Introduction 16 PE7328 1 2 3 4 1 PE7328 5 5 ...
Page 27: ...Chapter 1 Introduction 18 PE9330 1 2 6 3 4 1 6 PE9330 5 ...
Page 34: ...eco PDU PE Series User Manual 25 Installation Diagram 6 2 3 2 4 5 ...
