S
TARTING
UP
G-13.mft MDB/S1
30
National Rejectors, Inc. GmbH, Buxtehude
1
3
2
4
5
7
6
8
Fig. 5b:
Connect G-13.mft, front entry model,
to NRI sorting device
... on the front entry model
1
If necessary, fasten holding plate
1
with two screws
2
and
3
to
sorting device
4
(see Fig. 5b).
2
Remove screw
5
from coin validator.
3
Use the holding plate to insert the sorting device from the right-hand
side onto the coin validator.
4
Fasten the sorting device with screw
5
to the coin validator.
5
Use the 3-pole sorting plug
6
on the PCB
7
and on the rear of the
coin validator to connect the sorting device to the G-13.mft with the
help of the appropriate sorting cable.
6
Use the 10-pole connecting plug
8
on the PCB
7
and on the rear of
the coin validator to connect the sorting device to the G-13.mft for
power supply of the sorting solenoids with the help of the appropriate
connecting cable.
7
Use the 10-pole connecting plug
8
on the PCB
7
and the same
connecting cable to connect the coin validator to the vending
machine (see also section "Starting up in the vending machine" in
this chapter).
Summary of Contents for G-13.mft MDB/S1
