44
BA_v2_eagle_parallel_EN_1-0
T
echnical
DaTa
10
Technical data
This chapter contains
•
all relevant v
2
eagle data
•
details concerning the machine interface
•
information concerning v
2
eagle accessories
10.1
Device data
Supply voltage
10 V to 28 V DC
Current consumption max.
Acceptance solenoid: approx. 3 W
when accepting coins
Sorting solenoid:
approx. 2 W (max. 2 at the same time)
U
nom
= 12 V
Without sorting:
approx. 400 mA (for approx 150 ms)
With sorting:
approx. 800 mA (for approx. 250 ms)
U
nom
= 24 V
Without sorting:
approx. 300 mA (for approx 150 ms)
With sorting:
approx. 600 mA (for approx. 250 ms)
Dielectric strength, in/outputs
28 V max.
Current load, outputs
10 mA max. (open collector)
Temperature range
0°C to 60°C
Temperature change
Max. 0.2°C/min.
Rel. humidity
up to 93%
Condensation
not permitted
Machine interface
BDTA
6 coin signal outputs (open collector) (active low ≤ 0.8 V)
6 single inhibit signal inputs (open collector) (active high ≥ 3.7 V
(acceptance ≤ 0.9 V))
Common inhibit signal input (open collector) (active low ≤ 0.9 V
(acceptance ≥ 3.7 V))
Return signal output (active low ≤ 0.8 V at I = 20 mA)
For pin assignment refer to
Chap. 10.2.1 BDTA interface, p. 46
BACTA
5/6 coin signal outputs (push-pull, PNP/NPN transistor) (active high, VCOM
pos./active low VCOM neg.)
6 single inhibit signal inputs (TTL compatible, standby: high (5 V)) (≥ 3,7 V
(acceptance ≤ 0,9 V))
For pin assignment refer to
Chap. 10.2.2 BACTA interface, p. 48
Coin acceptance
32 coin types max. in 2 x 16 channels
Coin diameter 15–31 mm (optionally up to 32 mm, at 2.4-mm-thickness max.)
Coin thickness: 1.5–2.4 mm (optionally up to 3.4 mm)
Speed:
2 coins/s
Summary of Contents for v2 eagle
Page 2: ......
