3
4.5
Replace the Mattress
Replace the mattress on top of the bedguard.
WARNING:
The bedguard must always be
positioned with the extending bedguard rails facing
away from the headboard.
5. OPERATION
AND
USE
5.1
Extending the Bedguard Rails
The bedguards can be extended to give the user
better protection from bed roll-out.
1
1
Button
-clip
To extend the bedguards, pull the bedguard
extension rail out from the main bedguard rail until
the bedguard extension rail button-clip clicks into
position.
Note:
Make sure that the button-clip has fully
engaged into the hole.
5.2
Retracting the Bedguard Extension Rail
The bedguard extension rail must be closed to let
the user exit the bed.
To close the bedguard extension rail, press and hold
the button-clip, then slide the bedguard extension
into the main bedguard rail.
5.3
Remove the Bedguard Rail
The bedguard rails can be removed to enable the
user to make the bed.
2
3
3
1
1. Push and hold the right-hand side bedguard rail
button-clip, then pull the bedguard rail until the
button-clip disengages from the hole.
2. Repeat step 1 for the left-hand side.
3. Make sure both button-clips have disengaged
from the holes, then pull the bedguard rail out
from the base frame.
4. To
re
fi
t the bedguard rail, refer to Section 4.1.
5.4
Remove the Mesh Cover
The bedguard is supplied with the mesh cover
fi
tted
to the bedguard rails, to remove for cleaning, please
do the following:
Undo the Velcro fastener and slide the mesh cover
o
ff
the bedguard rail.
5.5 Re
fi
t the Mesh Cover
1. Slide the mesh cover onto the bedguard rail and
secure with the Velcro fastener.
2. Make sure that the mesh cover is fully secure
before use.