2
Note:
The handle height must be set up correctly for
the user height. Refer to Section 4.4.
Insert 1 x bolt, making sure the bolt head slots into
the hexagonal recess.
Note:
The hand-wheel must always be on the
outside of the rollator frame.
Attach the hand-wheel and washer, then tighten fully
by turning clock-wise.
Repeat for the opposite side.
Note:
Make sure both handles have been set to the
same height.
4.3 Fitting the Backrest
Insert the backrest into the slots on either side of the
rollator frame until the button clips click into place.
Note:
Make sure both button clips have fully engaged
the holes.
4.4 Handle Height Adjustment
Adjust the rollator handle height so that when the
user’s arm is down to their side, the hand-grip is
at wrist height. This will ensure the arms are at an
approximate 20°-30° bend when using the rollator.
Undo and remove the hand-wheel by turning anti-
clockwise, then remove the bolt and washer.
Adjust the handle height to the required position,
then secure using the bolt, washer and hand-wheel.
Refer to Section 4.2.
Repeat for the opposite handle.
Note:
Make sure both handles have been set to the
same height.
4.5 Fitting the Basket
Hook the basket over the front of the rollator frame in
the position shown.
Note:
The maximum safe working load for the
basket is 5kg.
