Metal detector
GB
4. Tighten the fixing screw properly.
5. Insert the search coil cable plug into the five pin jack on the back control box’s housing.
6. Lengthen or shorten the stem, so when you stand upright with the detector in your hand, the
search coil is level with and about 1~5cm above the ground. After that tighten the lock nut.
Caution:
•
The search coil cable plug fits into the connector only one way. Do not force the plug or you
could damage it.
ADJUSTING THE SEARCH COIL
Loosen the knobs at the search coil’s end, then adjust the search coil to the desired angle.
(The search coil should be parallel with the ground.) Tighten the knobs just enough to keep
the search coil from rotating or wobbling.
INSTALLING BATTERY
You need two 9V alkaline batteries to power your detector.
Cautions:
Use only fresh battery of the required size and recommended type.
1. If the detector is on, turn the power switch (on the control panel) to
Summary of Contents for 5705858717234
Page 34: ...Metal detector...
