Page 5
Assembling the Seam Phantom
®
Caution
Always be sure that the tool is switched off and unplugged before performing any work on the tool.
1.
If installed, remove rubber wheel guard (item 1) from polisher (See Figure 1 below).
Guard will not be needed with the Seam Phantom®.
2.
Using a 3mm Allen or Hex wrench, remove quantity (4) 4mm diameter Hex screws (item
2) from head of Polisher at the locations shown in Figure 2 below. Do not remove the
polisher head. Save the screws to reassemble the polisher if it is removed from the
Seam Phantom® in the future.
Item 1 – Wheel Guard
FIGURE 1 -
Wheel Guard Removal
Item 2 – 4mm Screws
FIGURE 2 –
Screw Removal
!
Summary of Contents for 0010-1
Page 14: ...Page 14 FIGURE 6 Cleaning...
