© Brüel & Kjær Vibro
● C104958.002 / V04 ●
Page 5 of 32
Technical alterations reserved!
Brüel & Kjær Vibro
│
Instructions Sensor ds821 4 mm
Safety
EN
UNRESTRICTED DOCUMENT
1
Safety
NOTE!
This manual is a part of the product. Read the manual carefully before using the product
and keep it accessible for future use.
CAUTION!
This symbol warns of dangerous situations which can result from misuse of the product.
NOTE!
This symbol provides general and useful information for using the product.
1.1
Disclaimer
Observing this technical documentation is a basic requirement for the proper and safe operation of
the product. We accept no liability for personal injury, damage to property or financial loss caused by
failure to observe this technical documentation. In such cases, any liability for material defects is
excluded.
1.2
Intended usage
The eddy-current displacement sensor system is intended solely for measuring mechanical distances
and oscillations and is used primarily for the condition monitoring of slide bearings or rotating shafts.
The use of the measuring chain is indoors or outdoors, when the driver is installed in a suitable
protective housing.
If sensors and cables are used in a way not described in the relevant user manuals, function and
protection may be impaired and serious personal damage, death or serious, irreversible injuries may
result.
•
Exclusively use sensor as specified in data sheet. Any use other than specified is considered
inappropriate. Brüel & Kjær Vibro does not assume any liability for damages resulting from
inappropriate use. The user is solely responsible.
•
Mounted sensors must not be used as steps.
•
Ensure that system is exposed only to admissible environmental influences specified in
technical system data sheet.
•
Maintain electrical equipment in regular intervals. Remedy defects, e.g. loose wires, defective
connectors, immediately.
