Page 6 of 32
© Brüel & Kjær Vibro
● C104958.002 / V04
Technical alterations reserved!
EN
Hot surfaces
•
In line with the user manuals, sensors and cables can be operated in extensive ambient
temperature ranges, whereby they can become hot through self-heating on housing walls and
can produce burning.
•
When mounted at external heat or cold sources (e.g. machine parts), systems, sensors and
cables can adopt dangerous temperatures, whereby burning, among other things, can occur in
the event of contact.
1.3
Limitations
The eddy-current displacement sensor system may be used only within the scope defined by the
technical specifications.
Limitations of the user manual
Not all assembly and connection options are described in this manual.
1.4
General information
Never put damaged products into operation. Immediately report any damage.
1.5
User Qualification
Ensure that all work in conjunction with our systems is performed by skilled, expert and authorized
workers (for ATEX systems according to EN 60079-14). Among these works are:
Installation and Commissioning
Installation and commissioning primarily concern work on electrical equipment. These works may be
performed exclusively by electricians or workers instructed and supervised by an electrician in
accordance with electrotechnical regulations/directives.
Change of System Specification
Any change of system specification has its effects on monitoring process with stationary systems and
on the measuring sequence with portable measuring systems.
1.5.1
Recommendations to User
If the use of the system in conjunction with machines or plant sections can produce risks outside of
Brüel & Kjær Vibro's responsibility, the user is expected to prepare and distribute safety technical
instructions or warnings and to ensure that the personnel concerned has received and understood it.
CAUTION!
If system is integrated into a machine or designed to be assembled, commissioning must
not take place until the machine the system is to be integrated in conforms to the EC
directives.