8
Fig. 1
Fig. 2
Fig. 3
Positioning
5-1 Connecting the Power Cord
Align the shape of the Power Cord Plug with the inlet on the rear of the
Control Unit, and fully insert it (Fig. 1).
When disconnecting the Power Cord, firmly grip the Control Unit and the
Power Cord plug, then pull the plug straight out.
5-2 Connecting the Foot Control
Align the positioning of the Foot Control Cord Plug (the mark) with the
Foot Control Cord Socket on the rear of the Control Unit, and fully insert it
(Fig. 2).
When disconnecting the Foot Control cord, firmly grip the Control Unit and
the Foot Control Cord Plug, then pull the plug straight out.
5-3 Connecting the Motor Handpiece
Align the positioning of the Motor Handpiece cord plug with the Motor
Cord Socket on the front of the Control Unit, and fully insert it (Fig. 3).
When disconnecting the Motor Handpiece cord, firmly grip the Control
Unit and the Motor Handpiece cord plug, then pull the plug straight out.
5
Preparations for Use
5-4 Attaching / Removing the Handpiece
• When disconnecting a cord, make sure to grip it by the plug. Removing by pulling the cord may
cause it to break.
CAUTION
• Attach or disconnect the Handpiece only after the power has been turned OFF and the bur has
completely stopped rotating.
• After attaching the Handpiece, make sure the Handpiece is securely connected to the Motor.
CAUTION
Motor Handpiece (VOLVERE i7 RM)
Removing:
Turn the bur lock ring of the Handpiece from the LOCK position
further towards the LOCK direction (Fig. 4).
Attaching:
Turn the bur lock ring of the Handpiece in the OPEN direction.
• This product can also be connected to motors for NSK VOLVERE Vmax (GX35RM & SCD, GX35M
& SCD).
NOTICE
Fig. 4
