INFORMATION & OPERATING INSTRUCTIONS
DO NOT OPERATE MACHINE UNTIL YOU HAVE READ THIS SECTION
IMPROPER USE OF THE PREDATOR CXC100 WILL VOID THE WARRANTY
1. Always use defoamer when foaming occurs to prevent vac motor damage.
2. To keep fitting and lines from damage during freezing conditions, use an
anti-freeze in the pump or keep equipment inside heated areas.
3. All extension cords must be at least size #12 (12/3) and no longer than 50 ft.
4. Do not let pump run dry.
5. Use neutral pH, water-based products only - NO SOLVENTS!
INSPECTION:
Carefully unpack and inspect the PREDATOR CXC100 for shipping damage. Each unit is tested
and inspected before shipment. Any damage incurred during shipping is the responsibility of
the carrier, who should be notified immediately.
CLEANING SOLUTIONS:
We recommend liquid cleaning chemicals. Powders may be used, but unless mixed very
thoroughly, they could cause build-up in the lines, pump, quick-disconnects, etc. A pH of 7-9 is
strongly recommended to avoid premature pump wear, which would void the warranty.
MAINTENANCE:
For optimum performance, flush the machine with clear water at the end of each working day.
Once a month, minimum, run a flushing compound through the machine to cut any alkaline
build-up that may have formed.
Lubricate wheels, casters and hinges as needed. The pump and vacuum motors do not require
any maintenance.
The body can be cleaned with a general all-purpose detergent and protected with a silicone
type product like Armor All®. The quick-disconnects should be lubricated with silicone, also.
Prior to each job, inspect the holding tank filter and the recovery tank float filter for hair and dirt.
The drain valve should also be inspected regularly and kept free of any debris or build-up.
https://harrissupplyind.com - To Order Parts Call 608-268-8080
