Asphalt and concrete cutters
Operation manual
page 6
issued
0
1/2017
prohibited to operate the machine until
fixing the problem.
2. During operation use suitable working dress
required by related regulation (helmet, ear
protection, protective glasses, gloves, shoes,
etc.) Don’t wear loose or torn clothes, chains
or jewelery which could be caught by
moving part of the machine and cause
injury.
3. Before beginning the work check if it is
possible to start the machine without
causing harm to the operator or other people.
4. Don´t start the engine in closed rooms, if
sufficient air ventilaiton isn´t ensured.
5. During operation pay full attention to
operating the machine, to not cause harm to
the operator or other people or to not cause
any collision with obstacles or other
machines and vehicles.
6. Check the machine during operation for any
unusual noise or for smoke which could
signalize any defect. In such cases stop the
operation immediately and arrange repair of
the machines.
7. Stop the engine before refuelling. Avoid
contact of fuel and hot parts of the engine.
Don´t fill the fuel up to the edge of the tank.
Clean any fuel which runs over the tank.
8. It is necessary to keep the fuel tank tightly
closed. Close the fuel tap when not in
operation. Drain the fuel before transporting
the machine for longer distances.
DANGER! Leaking fuel tank and distribution
may cause explosion. Replace these parts
immediately if damaged.
9. It is prohibited to operate the machine in
areas with danger of explosion of flammable
gas or dust.
10. If operated in closed spaces (halls, tunnels,
pits), sufficient air ventilation must be
ensuredo not operate the machine in areas
with explosion danger.
11. After finishing operation, turn the engine off
and store the machine in a safe place and
secure it against stealing or unauthorised
use. Store the machine so it would not fall or
overturn or hinder the movement of other
machines or vehicles.
1.1.5. Maintenance and Service
1. Check the technical condition of the
machines regularly, with special attention to
proper function of protective and control
units. In case of any defects ensure the
repair.
2. Service works can be done only by qualified
person authorized by the machine user or
worker by service company.
3. Service works can be done only at such
place, where the ecological regulation,
cleanness and safety of the work. If possible,
do the service work in workshop with
sufficient equipment.
4. Service works can be done only when
engine is turned off. If the engine needs to
be started for some purposes, pay full
attention to work safety.
5. Always use only original spare parts. Only
original spare parts were tested by the
manufacturer and guarantee safe machine
operation.
6. Any changes and modifications of the
machine can be done only with explicit
approval of the manufacturer.
1.1.6. Transport and Storage
1. It is allowed to use only equipment with
sufficient carrying capacity for loading and
transporting the machine (machine weight is
mentioned in chapter “Basic technical
parameters”.
2. When loading the machine by crane, it is
necessary to oblige the valid rules of
working with crane. This can be done only
qualified person with proper authorization.
3. Attach the hoist belts to indicated machine
spots.
4. When manipulating by hand, usually
cooperation of more people is necessary, so
the maximum lifting limit for one person
would not be broken.
