1
IP CAMERA CONFIGURATION IN ENVIROMUX WEB INTERFACE
The IP cameras in the chart below
can be monitored by the E-16D/5D/2D and be used to take snapshots and attach them to
alert messages sent to users in the E-16D/5D/2D.
The images that are attached will be at the default resolution for each camera:
Model
Default Resolution
Current Firmware Version
E-IPCAM-HNPO-P
1920x1080
v2.800.00AC001.0.R, Build Date: 2020-09-04
E-IPCAM-DHNPO-V2P
1920X1080
v5.4.5 build 170124
E-IPCAM-WHNPT-V4
1920x1080
v2.800.0000000.1.R, Build Date: 2019-09-27
Materials Included:
Model
Power Supply
E-IPCAM-HNPO-P
100-240V @ 50/60Hz Input/ 12VDC 1A Output w/ country specific line cord
E-IPCAM-DHNPO-V2P
100-240V @ 50/60Hz Input/ 12VDC 1A Output w/ country specific adapter
E-IPCAM-WHNPT-V4
100-240V @ 50/60Hz Input/ 5VDC 1.5A Output w/ country specific adapter
To configure the IP camera to capture this image, enter the indicated text in the “
Image URL
” box on the “
Configure IP
Cameras
” page of the ENVIROMUX Web Interface. Also add the URL Type, IP address, Username and Password as
indicated.
For E-IPCAM-HNPO-P:
Image URL
: <IP ADDRESS>/onvifsnapshot/media_service/snapshot?channel=1&subtype=0
URL Type:
JPEG
Default IP Address:
see instruction on page 6
Default Username:
admin
Default Password:
admin
(if you change settings in the camera, you will have to change this.)
For E-IPCAM-DHNPO-V2P
Image URL:
<IP ADDRESS>/streaming/channels/1/picture
URL Type:
JPEG
Default IP Address:
192.168.1.64
Default Username:
admin
Default Password:
none-
enter the password you assigned when you setup the camera
For E-IPCAM-WHNPT-V4:
Image URL:
<IP ADDRESS>/onvifsnapshot/media_service/snapshot?channel=1&subtype=0
URL Type:
JPEG
Default IP Address:
see instruction on page 6
Default Username:
admin
Default Password:
admin
(if you change settings in the camera, you will have to change this.)
For all models, be sure to put a checkmark in “
Enable HTTP Auth
”..
Other ENVIROMUX Support
The IP cameras listed can all be
monitored only
(no snapshots) using the E-MICRO-TRHP. (The E-MICRO-TRHP requires
firmware version 3.11 or newer).
The E-IPCAM-WHNPT-V4 and E-IPCAM-HNPO-P can be used with the E-MINI-LXO and it can be monitored and take
snapshots to attach to alert messages.
Only the E-IPCAM-WHNPT-V4 and E-IPCAM-HNPO-P can be used with the E-1W model and it can only be monitored (no
snapshots).
See compatibility table on next page.
