IP Setting:
The System provides access to changing settings over a web browser. Enter the IP address of transmitter / receiver (found
on the label on the bottom of the unit) into the URL bar of your browser. If the label is missing or cannot be identified you can
find the IP address as described below:
Methods to get the IP address of receiver:
1.
Connect the monitor with the receiver. The “
local
IP” displays
on the right bottom of the screen when the receiver is
booting without the transmitter connected (or no video input)
2.
Press IR Remote Control buttons
MENU, 1, ENTER
(Network Information). It will display the receiver IP Address on
screen
3.
Install Internet Explorer browser plug-in: Bonjour. Click the device name to enter web setting page and get the IP
address (please refer
Bonjour plug-in installation: Page 21
)
4.
Run “Device Manager” of
Stream Control Panel
program (attached in transmitter package), enter the
Client
page (please
refer software instruction)
Methods to get the IP address of transmitter:
1.
Connect the monitor with the receiver, connect the receiver with the transmitter and set them in the same channel.
Do
not
connect video source to transmitter. , the “
remote IP” will display
on the right bottom of the screen
2.
Install Internet Explorer browser plug-in: Bonjour. Click the device name to enter web setting page and get the IP
address (please refer
Bonjour plug-in installation: Page 21
)
3.
Run “Device Manager” of
Stream Control Panel
program (attached in transmitter package), enter the
Host
page (please
refer software instruction)
System default IP setting is a Static IP. The IP is mapped to last 4 digits of the MAC address (Hex),
for example: For MAC XX:XX:XX:XX:
12:AB
, the IP address will be 169.254.
18.171
If the IP address on the label of transmitters/receivers is incorrect (maybe changed by someone), it can be reset to the
default using two methods:
1.
Press and hold the channel button “
-
“ , then power ON (power and link LEDs will flash) to reset to default.
2.
Press IR remote control
MENU, 3, 3, 3, ENTER
to reset to default.
22
