- 2 -
2.
Precaution for Safety
This machine is designed and manufactured for parts feeding equipment based
on a concept of trouble-free operation and labor saving, while responsibility on
user oneself is also important for safety. Read this manual carefully before
starting use, and be sure to follow the description below on safety. Also be sure
to follow the warning and caution label attached to the body.
WARNING
Indicates a potentially hazardous situation which, if not avoided, will
result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which, if not avoided, will
result in minor or moderate injury or property damage only.
WARNING
The most dangerous position of the machine is electric equipment. Be sure to connect a
grounding wire. Incompliance may result in electric shock.
Do avoid use in the atmosphere of explosive gas or flammable gas, or in a wet place.
Explosion or fire hazard may be caused.
CAUTION
Do not use the machine in a place exposed to splash of water, outdoors, or in a place of
extremely low temperature or high temperature and high humidity. (See the next page for
environmental condition in use.)
y
This machine is a heavy material. (See the specification in item 11 for the mass.) In
transporting the machine, wear safety shoes, watch out for dropping, and take due care.
y
Fix the machine securely after installation.
y
Do not conduct the installation and assembly work with bare hands.
y
As for a chute equipped with array mechanism, pay attention to the sharp edge and do
not touch with bare hand. Be sure to wear gloves.
Do not use the machine on a base lacking in sufficient strength or in an unstable place. The
specified performance of the machine may not be observed.
Do not place the body in inclination. The specified performance of the machine may not be
observed.
Please do not scratch, pull or forcibly bend the wiring. Moreover, when a heavy thing is put
on it, or it is pinched, the wiring will damage. It causes a fire or an electric shock.
When welding the machine to a chute, be sure to connect the grounding clip of welder to
the chute. If welding ground is insecure, the grounding wire connecting the body and the
controller may be burnt, resulting in electric shock or leakage.
