- 3 -
For proper use
[1] NTN mono-drive 2-way feeder is a vibrating machine with a mechanism to align specified parts in a
certain direction mounted on a chute to feed parts in bulk state to a specified position in alignment and
regular series. Do not use the machine for other purposes such as equipment for material test and
sieve.
[2] Use the NTN mono-drive 2-way feeder in conformance to instructions in this operation manual and
packaged manual. See the specification in item 11 for technical specification.
[3]
This Instruction Manual is for the body with part number design change code B and C of NTN
mono-drive 2-way feeder
, and is not applicable to the body without design change code and with
design change code A of conventional machine.
[4] Be sure to use NTN controller for NTN mono-drive 2-way feeder. Also, use a controller and power
supply compatible with this machine.
[5] Generated noise level depends on the specification of this machine, material of parts to be fed, etc.
When noise level is above acceptable limit, take a noise insulation measure with noise insulation cover,
etc.
(Note 1)
Do not use the machine when it is not in complete condition (abnormal noise, abnormal
vibration, chipped parts, etc).
(Note 2)
When a chute is equipped with array mechanism for specified parts to be fed, only such
specified parts can be fed.
(Note 3)
Environmental condition in use
Ambient working temperature
0 to 40
°
C
Ambient working humidity
30 to 90% (Free from condensation)
Working altitude
Below 1,000 m
Storage temperature in transport
−
10 to 50
°
C
Atmosphere of use place
Not exposed to water, chemical, etc.
Free from combustible gas and corrosive gas.
Use only indoors.
What should be observed by users
[1] Follow the instructions in this operation manual and other manuals in any work such as operation,
maintenance, and repair.
[2] Avoid such use that may deteriorate the safety of NTN mono-drive 2-way feeder. When any sign of
change is found which may harm safety, inform NTN of details.
(Note)
NTN mono-drive 2-way feeder must be installed, operated, maintained, and repaired by a
special expert. Further, make sure that only authorized personnel are in charge of operation.
