114
Ap
pen
d
ix
ATS103=<n>
[&F] [?]
Set the delimiter when dialing
with a destination sub-address.
n=0 :
＊
(Asterisk).
n=1 (default)
: / (Slash).
n=2 :
￥
or back slash.
ATS103=0
OK
ATS104=<n>
[&F] [?]
Set the delimiter when dialing
with an originating sub-address.
n=0 : # (Sharp).
n=1 (default)
: % (Percent).
n=2 : & (Ampersand).
ATS104=0
OK
ATV<n>
[&F] [&W]
Set the display method of the
result code.
n=0 : Display in numeric
characters.
n=1 (default)
: Display in text.
ATV1
OK
ATX<n>
[&F] [&W]
Set to detect the busy tone and
dial tone, and to display the
communication speed.
n=0 : Not to detect busy
tones, not to detect
dial tones, not to
display speed.
n=1 : Not to detect busy
tones, not to detect
dial tones, display
speed.
n=2 : Not to detect busy
tones, detect dial
tones, display speed.
n=3 : Detect busy tones, not
to detect dial tones,
display speed.
n=4 (default)
: Detect busy tones,
detect dial tones,
display speed.
ATX1
OK
ATZ
Reset the settings on the FOMA
terminal with the nonvolatile
memory contents. If performed
during a communication, the line
is disconnected.
ー
(On-line command
mode)
ATZ
NO CARRIER
(Off-line)
ATZ
OK
AT Command
Overview
Parameters/Descriptions
Command Examples
A
T
Co
mm
and
List
