34
If a COM port of "FOMA SO706i" cannot be
selected
Click "
キャンセル
" (Cancel) to close the "
接
続の設定
" (Connection Settings) screen and
then follow the steps below:
(1) Select "
ファイル
" (File) menu
→
"
プロパ
ティ
" (Properties)
(2) Select "FOMA SO706i" in the "
接続方法
"
(Connection method) column of the "
接続
の設定
" (Connection Settings) tab on the
"sample
のプロパティ
" (sample
Properties) screen
(3) Uncheck "
国 / 地域番号と市外局番を使
う
" (Use the Country/Region Code and
Area Code)
(4) Click "OK"
7
Enter the access point (APN) and
press
Enter in the format of AT+CGDCONT=<cid>,
"PDP_type", "APN"
<cid>
：
Enter any number from 2 or between 4
and 10.
Please be cautious because if cid has been
already set, the setting will be overwritten.
"PDP_type"
：
Enter "PPP" or "IP".
"APN"
：
Put " " around the access point (APN)
to enter.
If "OK" is displayed, the settings for the access
point (APN) are completed.
Example: To enter APN named XXX.abc in cid
Number2
Enter AT+CGDCONT=2,"PPP","XXX.abc"
.
8
Confirm that "OK" appears and click "
ハイパーターミナルの終了
" (Close
Hyper terminal) in the "
ファイル
" (File) menu
""sample"
と名前付けされた接続を保存しますか？
" (Are you going to save the connection "sample"?)
appears, but it is not necessary to save.
NOTE
d
The AT commands entered in "Hyper terminal" may not be displayed after Step 7 on p.34. In this case, if you enter
ATE1
, AT commands you enter from then on are displayed.
d
To reset the access point (APN) settings using the AT command
・
If reset, the access point (APN) setting with cid=1 will return to "mopera.ne.jp" (Default value) and cid=3 to "mopera.net" (Default
value), and cid=2, 4 through 10 will be unregistered.
<How to enter>
AT+CGDCONT=
(to reset all cid)
AT+CGDCONT=
〈
cid
〉
(to reset a certain cid only)
d
To confirm the access point (APN) settings using the AT command
・
Display the current settings.
<How to enter>
AT+CGDCONT?
