44
Bef
ore Using the Han
dset
Checking the Battery Level
<Battery level>
The battery level is indicated only as a guide.
Checking the battery level with icon
When the FOMA terminal is turned on, the icon
indicating the remaining battery level is displayed.
Checking the battery level with sound
and animation
The current battery level is indicated by sound and
animation.
1
i
“SETTINGS” “Other settings”
“Battery level”
The check screen is displayed, and beeps sound
in accordance with the level. The battery level
animation disappears in about 3 seconds.
“3 short beeps” : Full charge.
“2 short beeps” : Partial charge.
“1 short beep”
: The battery is almost running
out. Recharge the battery.
When the battery runs out
The screen as shown on the left
appears and the low-voltage
alarm sounds. The alarm sounds
for about 10 seconds and the
power is turned off in about 1
minute. To stop this alarm, press
any key (except for side keys).
Turning the FOMA Terminal
On/Off
<Power
ON/OFF>
Turning the FOMA terminal on
z
Before turning the FOMA terminal on, make sure
that the FOMA card (UIM) is inserted correctly.
1
y
(1 second or longer)
After Wake-up screen appears, the standby
screen or initial settings screen appears. If you
have just attached the battery pack or you turn
the FOMA terminal back on immediately after
turning it off, “Wait a minute” message may
appear for a short time.
■
When “
” appears
You are outside the FOMA
service area or in a place
where radio waves do not
reach. Move to a place where
the radio reception level icon
such as “
” appears. The
reception level is displayed
as follows:
■
If the Initial setting screen appears
→
p.45
■
If the PIN1 code/PIN2 code entry screen
appears
→
p.100
N
z
The center illumination lamp lights up in red during
charging. The charge lamp turns off when charging
ends (Full charge). If the FOMA terminal is turned on,
“
” flashes during charging and “
” lights when
charging ends.
You can set illumination for charge start/end.
→
p.92
z
The battery pack cannot be charged separately.
Always charge the battery pack while it is attached to
the FOMA terminal.
z
If the battery runs out, the center illumination lamp may
not lights up right away, but the charging itself has started.
<AC adapter/DC adapter>
z
When the center illumination lamp of the FOMA terminal
(Phone) and “
” on the display disappears, and the
message “Charge unusual Stop charge” is displayed,
disconnect the FOMA terminal from the AC adapter or
DC adapter and remove the battery pack. Then set them
again for recharging. If the same error occurs again,
there may be a problem or fault on the AC adapter or DC
adapter. Contact a DOCOMO shop or service counter.
z
The DC Adapter uses a 2A fuse. If the fuse (2A) blows,
always use a fuse with the same specifications. Fuses
(2A) are consumable items. Purchase a replacement
fuse at your local car accessory shop, etc.
<Desktop holder>
z
Attach the FOMA terminal to the desktop holder
securely. Also, take care not to pinch the strap.
: Full charge.
: Partial charge.
: The battery is almost running
out. Recharge the battery.
N
z
The recharge battery screen and 3 short beeps sound
during a voice call and the recharge battery screen
(“
カメラオフ
Camera Off” message to the other
party) appears during a videophone call to notify. Note
that the call will be disconnected in about 20 seconds
and the power turns off in about one minute.
N
z
When you change the FOMA card (UIM), you have to
enter the 4 to 8 digit security code after turning on the
FOMA terminal. The standby screen appears when the
security code is successfully entered. When you enter
wrong security code for 5 times, the FOMA terminal turns
off (however, you can turn on the FOMA terminal again).
Ｒｅｃｈａｒｇｅ ｂａｔｔｅｒｙ
Standby
Good
Poor
