43
Bef
ore Using the Handset
Setting the Date and Time
<Date/time>
You can set the date and time either by automatically correcting the time based on the
time information obtained from the DoCoMo network or by manually setting the time.
Example: Correcting the time automatically
1
From the Menu, select [Settings]
→
[Management]
→
[Date/time] and press
.
Ａｕｔｏ ｔｉｍｅ ａｄｊｕｓｔ
ＯＮ
Ｍａｎｕａｌ ｃｌｏｃｋ ｓｅｔ
Ｄａｔｅ／ｔｉｍｅ
[Auto time adjust] :
Set the time automatically.
[Manual clock set] :
Enter the time manually. When you set the time using the
Manual clock set, the Auto time adjust is set to [OFF].
2
Select [ON] at [Auto time adjust].
[ON] :
Correct the date and time automatically.
[OFF] :
Do not correct the date and time automatically. Set the time using the Manual clock set.
To set the time manually
Select [Manual clock set]
→
[Yes] and enter the year and date within the range from
2000/01/01 to 2050/12/31, the time in 24-hour format (00:00 to 23:59), and select
time zone. Press
(Complete).
●
When you set the Auto time adjust to [ON], the date and time are corrected automatically when the FOMA
terminal is powered on with a UIM installed. Note, however, that there may be an error lasting several
seconds. The time cannot be automatically corrected in the following cases.
- Outside of the service area (The time may not be corrected automatically even inside the service area
depending on the radio wave condition.)
- While
i-
α
ppli is running
●
The date and time settings are retained even when you replace the battery pack. However, if you leave the
FOMA terminal without a battery pack or with a fully expended battery pack, the date and time may be reset
to “----/--/-- --- --:--”. In this case, set the date and time once again.
●
If the date and time are not set, functions that use the clock, such as the current time icon, Schedule, Alarm,
Booking program, Timer recording, i-
α
ppli Auto-start, and calendar/clock display cannot be used. The date
and time for the Redial/Received record and the date and time on images shot with the camera are also not
recorded.
●
When you receive time correction information from the network of the carrier to which the FOMA terminal is
connected during international roaming, the time is automatically corrected when the Auto time adjust is set
to [ON].
When the time is corrected to the local time, the date and time used for the Redial/Received record and
sent/received mail also are corrected to the local time and “
” appears. Note, however, that some overseas
networks may not perform time correction.
