DOC RPM_EL80_010117006
4
OPERATION:
As the need for ventilation will vary from home to home, the unit is
equipped with a humidity control and a speed control for flexible
operation. The humidity control monitors humidity. When the ambient
relative humidity (RH) exceeds the set point on the humidity dial, the fan
will go to high speed until RH drops below the setpoint. The speed
control is used to set fan speed for continuous operation (if desired)
whenever the humidity control is not triggering high speed operation.
Turing the speed dial clockwise from OFF changes fan speed from a
higher to a lower range. The table below explains various ways to operate
your Eliminator.
Operation
Set Humidity Dial to:
Set Speed control to:
OFF
OFF
OFF
Low Speed Continuous
OFF
Desired setting
High Speed Continuous
ON or OFF
High speed range
Intermittent High Speed, based on
ambient RH
Desired RH setting. Unit goes to
high speed while RH is above
setpoint.
OFF
Low speed with intermittent high
speed, based on RH
Desired RH setting.
Desired low speed setting.
Typical Humidity Dial Settings.
Fall to spring: 40-60%; summer: OFF.
MAINTENANCE:
Every 3 months, check hood for blockage.
YOUR
NU-AIR
ELIMINATOR 80
TRANSFERABLE WARRANTY
(CANADA AND THE USA)
Should your NU-AIR Eliminator 80 cease to function within two (2) years of the original date of purchase due to
defective material or workmanship of the product, Nu-Air Ventilation Systems Inc. will replace FOB Factory the
defective part. Delivery, installation and labour cost are not covered by this warranty. This warranty does not
cover damage to the unit while your possession (other than damage by defective parts or material). Improper
maintenance voids this warranty. If the unit is put to commercial use or application other than residential use, the
warranty is for a period of one (1) year.
16 Nelson St., P.O. Box 2758, Windsor, Nova Scotia, B0N 2T0
Tel: 902-798-2261 Fax: 902 798-2557
