7
Leaflet Number 671051 January 2012
Installation and Maintenance
XS Wall Fan Kits
Fix backplate box to the prepared wall.
Feed approx. 200mm of supply cable into the box
1
2
4
3
5
6
7
Fit the control into the backplate box and secure.
Test the installation.
Lift up panel and remove two screws to dismantle unit.
Spot through backplate box and drill and plug the wall.
Connect the end of the cable into the control block.
Fitting Remote Controller XS-MFC
or Remote Sensors (optional)
The XS-MFC Multi Fan Control provides supply or extract,
variable speed and automatic or manual switching of several
fans if desired, (see note below).
The control is best mounted approx 1.5m above the floor.
Remote Sensors are available for Humidity, Air Quality and
Passive Infra Red control.
Remote Sensors should be positioned at least 1.5m above the
floor and away from direct heat sources e.g. radiators.
Note: Up to 5 fans (size 6 / 9 inch) can be controlled by one
XS-MFC. Up to 3 fans (size 12 inch) can be controlled by one
XS-MFC. Do not mix different fan sizes on the same controller.
Push out backplate box cable entry using a screwdriver.
200mm
1.5m
