09/2022 ·
nuPro XS-8500 RC
3
General information
Never operate the loudspeaker unattended!
Danger of electric shock!
To avoid the risk of electric shock, the speaker may not be opened by
the user. There are no user-serviceable parts inside the speaker.
Service work and repairs are reserved for qualified specialists authorized
by Nubert. If you need service, please contact Nubert electronic GmbH
directly (info@nubert.de)!
Danger of suffocation!
Never let children use or play with the speaker, remote control or pa-
ckaging unattended. There is a risk that children will get caught in the
packaging film and suffocate. Make sure that children cannot remove
any small parts from the devices! These parts, like the remote control
battery, could be swallowed and cause suffocation. In case of swallo-
wing any parts, contact a doctor immediately!
Danger of injury or damage!
When moving the speaker, take care to avoid injury and damage!
Caution!
Since the speaker can only be completely disconnected from the mains
at the mains input on the rear of the unit or by pulling the mains plug
from the socket, it must be positioned so that you have free access to
the mains input or mains plug. If any of the following situations occurs,
the loudspeaker must be switched off immediately and disconnected
from the mains. Contact Nubert electronic GmbH (info@nubert.de)
immediately!
• The speaker has been damaged or has fallen down.
• Power cord or plug is damaged
• Objects or liquid have gotten into the loudspeaker
• The speaker has been exposed to excessive moisture or rain.
• The speaker does not work properly or exhibits a significant
reduction in performance.
• The loudspeaker smells burnt, develops smoke or makes
unusual noises.
Only use accessories recommended by Nubert!
Installation instructions
Caution!
An unstable location can damage the speaker.
• Only place the loudspeaker on a flat, stable surface and make sure that
it cannot be knocked over!
• Also make sure that no unintentional pulling can occur on the cables
to avoid knocking over the speaker or damaging the connection
sockets!
• Keep strong mechanical shocks away from the loudspeaker!
Caution!
Excessive heat build-up inside the unit can shorten its service life
or lead to fire.
• Never cover the back of the speaker! Make sure that there is a clea-
rance of at least 10 cm and sufficient air circulation in the back area!
• Do not operate the speaker and remote control near heat sources
such as radiators or stoves!
• Do not expose the speaker and remote control to direct sunlight.
• Never place burning candles or similar open fire sources on the
loudspeaker!
Danger of explosion!
Installation in unsuitable locations can cause explosions.
Do not use the speaker or remote control
• in environments where there is a risk of fire or explosion!
• at extremely low or extremely high temperatures!
• near flammable gases or vapours!
• near strong dust!
• near flammable materials!
Danger of electric shock!
The loudspeaker carries mains voltage and voltages higher than 35 V AC
or DC inside. It has no special protection against the intrusion of liquids
or objects into the system. There is therefore a risk of lethal electric
shock.
• Never touch the speaker with wet hands!
• Only use the speaker in a dry place!
• Do not operate it outdoors or in damp rooms!
• The loudspeaker must be protected from liquids of all kinds, including
dripping and splashing water.
• Do not place any containers containing liquids (e.g. flower vases) on
the speaker or in the immediate vicinity!
• If the loudspeaker is moved from a cold environment to a warm room,
condensation may form inside the unit. Wait at least six hours until
the loudspeaker has reached room temperature and is dry before
switching it on!
• No objects of any kind may get into the device.
• Should the loudspeaker come into contact with liquids or should
objects have gotten inside, please unplug the mains plug immediately
and contact Nubert electronic GmbH (info@nubert.de)!
Danger of injury or damage!
For speakers with threaded bushings on the underside:
The threaded bushings may be used for upright mounting of the loud-
speaker on suitable base plates or feet only.
The threaded bushings on the underside of the loudspeaker enclosures
are not designed for tensile loads and must therefore not be used as
holders for hooks or similar devices in order to suspend the loudspeaker
cabinet.
A falling speaker may cause serious injury and damage.
