4. Once the connection is complete, turn the pump on to test connection by holding the ON/
OFF button until the LED indicator emits a green light. You may begin using the pump at
this time. If the pump does not turn on, check all connections and ensure they are correct.
Batteries with a low charge or a faulty outlet could also be factors that may need to be checked
if pump still does not function. The LED indicator light will begin to flash red if the batteries
are beginning to lose their charge
Note: When disposing of electrical devices or components, care should be taken to ensure
that all local legal mandates are followed
PROGRAMMING THE ELECTRIC BREAST PUMP
A. LED Indicator light
B. ON/OFF Button
C. High Speed
D. Low Speed
E. Program
F. Clear
1. Turn on the breast pump by holding down
the ON/OFF Button. The LED light will emit a
green glow when it is on. To turn off simply
hold down the ON/OFF until the light turns off
2. Hold down the Program button until the
LED light flashes red.
3. While it is flashing red, input your desired
combination by pressing the High Speed
or Low Speed button in the sequence that
you want the pump to perform them. The
Programmable Pump Unit will remember this
combination for future use, even if turned off
or removed from a power source. To resume
a previously programmed cycle, simply press
the Program button
4. If you wish to stop the programmed cycle, you may press the clear button at any time. If
you wish to input a new pumping cycle, repeat the above steps.The previous programming
will be erased, and the new program will be stored
Nous suggérons qu’avant de commencer vous disposiez un essuie-main propre sur une surface
de travail plane pour y placer les différents éléments et éviter de les perdre
1.
Otez d’abord le couvercle de voyage de l’entonnoir
2.
Otez l’élément en silicone de l’entonnoir en tirant le bord de l’élément par-dessus le bord
de l’entonnoir.
3.
Otez le moteur électrique de votre tire-lait en tirant et en inclinant le moteur.
4.a+b. Otez la membrane à vide de votre tire-lait en faisant glisser vers le haut la tige du
diaphragme hors de l’encoche dans le levier de la pompe.
5.
Otez la valve de débit en l’abaissant et en l’éloignant du cylindre.
INSTRUCTIONS DE DéMONTAGE DU TIRE LAIT
AVEC MOTEUR éLECTRIqUE (IMAGE B)
™
A B C D E F
NTNV3_insert_electricaldrive67705-SMALLER.indd 14
14/02/2011 10:33:48
