5a.
Introduisez l’élément en silicone dans l’entonnoir et tirez les bords au-dessus de la lèvre
de l’entonnoir.
5b.
Assurez-vous que la valve de débit sur le cylindre situé dans l’embouchure de la pompe
soit bien fixée et en haut du cylindre.
7.
Connect a power source to your Programmable Pump Hood and your Nûby™ Natural
Touch™ Rhythm™ Electric Breast Pump. To ensure that there is a proper connection
between the motorised arm and the vacuum membrane post, hold the ON/OFF button
and allow the pump to cycle once; the vacuum membrane is now connected and your
pump is ready for use. If you do not want to use the pump immediately, you may choose
to remove the power source at this time and instead snap the travel cover over the
front of the funnel, and your pump should be clean and sterile until ready for use
CONNECTING A POWER SOURCE:
The Nûby™ Natural Touch™ Rhythm™ Electric breast pump allows you to choose between two
power sources, a wall cord which can plug into any standard electrical outlet, or a convenient
battery pack for travel. Connecting the desired power source is simple, and detailed in the
instructions below
1. Choose which power source best suits
your needs.
2. If you have chosen the wall cord, plug
it in to an electrical outlet close to where
you intend to begin expressing so that
you are not uncomfortable and that there
is a reduced possibility of the cord being
unplugged from the outlet while in opera-
tion. You should also try to ensure that the
cord does not impede the path of others
as it may present a trip hazard. If you have
chosen to use the battery pack, ensure
that the batteries have a good charge so that your pump functions as it should. The battery
pack uses 4 x AA batteries, which should be installed at the correct polarity. The batteries
should be disposed of according to the manufacturer’s instructions.
3. Once your power source has been established, you may now
connect it to the Programmable Pump Unit by inserting the jack,
located at the end of the cord connected to your power source,
into the socket on the Programmable Pump Unit as below
™
Push Jack into Socket ensuring it is fully seated.
NTNV3_insert_electricaldrive67705-SMALLER.indd 25
14/02/2011 10:33:56
