21
Nucleus Freedom Speech Processor
Note:
If you plug the coil cable into the Processing Unit when
the speech processor is turned on, the speech processor may
turn off. If this occurs, hold down the Select button to turn the
speech processor back on, that is, until you either hear sound
or the display shows.
Alternatively, the display may not show anything, while the
speech processor continues to operate. If this occurs, stop the
power to the Processing Unit, and then restart it. To stop the
power, you can either:
•
Hold down the Select button until the speech processor
is off.
•
Twist the Processing Unit and BTE Controller or
Bodyworn Controller shoe until they no longer connect,
then twist them back into place again.
•
Slide the battery holder out, then in again.
After you have done one of the above, hold down the Select
button to turn the speech processor back on, that is, until you
either hear sound or the display shows.
N31018F Iss1D03textmas.indd 21
N31018F Iss1D03textmas.indd 21
24/05/2005 4:14:22 PM
24/05/2005 4:14:22 PM
