26
Nucleus Freedom Speech Processor
Program selection
To change to another program, push the Select button briefl y
to move to the next program.
If you have the private tone operating, or with the Bodyworn
Controller either the private or public tone, when you change
to another program, the number of tones heard relates to
the program you are moving to. For example, if you are on
P2 and press Select, three sounds will be heard as you move
to P3. If you wish to move to P4 or P1 you need to wait until
the sounds fi nish before briefl y pushing the Select button
again. Repeat to move to P1.
If the private tone or public tone is not operating, no tone
will be heard when the Select button is pressed. However
there will be a slight gap in sound between the programs. If
you wish to continue to move on to another program, wait
until you hear the sound from the new program before you
press the button again.
That is, pressing the Select button when the sound gap is
occurring will not move the speech processor on to the next
program. You need to wait for the sound fi rst before you
again press the Select button.
Continue further brief pushes until you reach the program
you want. It will skip the setting where there is no program.
For example, if you only have two programs it will only move
through two settings.
The program selected operates until you press the Select
button again. When you switch your speech processor off and
on again, it will remember the last ‘active’ program, including
the microphone sensitivity and volume settings you were
using.
N31018F Iss1D03textmas.indd 26
N31018F Iss1D03textmas.indd 26
24/05/2005 4:14:41 PM
24/05/2005 4:14:41 PM
