27
Nucleus Freedom Speech Processor
Listening controls
You can use the microphone sensitivity and volume controls
to change the level of the sounds you hear.
You can adjust both the microphone sensitivity and the
volume levels for any program, unless they have been
set at a fi xed level by your clinician, when the programs
were established. Generally, you are most likely to vary the
microphone sensitivity, as you adjust to environmental sounds.
The microphone sensitivity and volume settings are saved
with the particular program. If you change to a new program,
the level will be the same as previously used with that
program, that is, the last saved value for that program.
Once you fi nd the level you want and you stop making
changes, the display will go back to the normal display after a
few seconds.
Whenever you wish to again change the level, repeat the
process.
To change between adjusting the microphone sensitivity and
volume, when both are available, press either the Increase or
Decrease buttons for at least a few seconds.
If your clinician has chosen to disable the microphone
sensitivity in a program, it will not operate and you will go
immediately to the volume setting when you press either side
of the Increase/Decrease buttons.
Similarly if your clinician has chosen to disable the volume
control, it will not be available.
N31018F Iss1D03textmas.indd 27
N31018F Iss1D03textmas.indd 27
24/05/2005 4:14:42 PM
24/05/2005 4:14:42 PM
