Manual
____________________________________________________________________________________________________
356 South Abbott Avenue, Milpitas, CA 95035, USA
•
PHONE: +1-408-627-7859
•
FAX: +1-408-262-6877
nuforce.com
•
EMAIL:
salesteam@nuforce.com
, support@nuforce.com
•
Skype: nuforce-sales
10)
MUTE: Mutes and reactivates the sound.
11)
MENU OPERATION KEYS: Press MENU to get to the Main Menu, and press Menu again to
exit. The
▲
/
▼
buttons move the cursor up/down.
12)
OK/EXIT: Press Ok to confirm selected function. Press Exit to return to your prior selection.
13)
VOLUME:
▲
/
▼
Volume control raises and lowers audio level in 0.5dB steps.
14)
CENTER: adjusts the center channel using VOLUME
▲
/
▼
15)
SUB: adjusts the subwoofer channel using VOLUME
▲
/
▼
16)
SETUP: Use in conjunction with On Screen Display (connect CVBS or S-video to a
TV/Projector). The video display will show adjustable parameters. Use
▲
/
▼
to select, and press
OK to set, then press
▲
/
▼
to change values. Press EXIT to save and exit at the current setting.
ON AND OFF
When first tuning on the AVP-17, the unit goes through an initialization routine and will display
NuForce and AVP 17 before arriving at the previously selected input and volume setting. Note: if the
volume was set higher than 60 when the unit was turned off, on the next power-on cycle the AVP-17
will ramp up to an initial volume level of 60.
INPUT SELECTION
Combinations Supported
Audio Input Mode
Video Output Mode
Input Analog
Coaxial
Optical
CVBS S-Video
YPbPr
DVD
CD
Cable
Aux1
VCR
Tape
Aux2
7.1Ch
With Remote Control
1)
Select
:
7.1CH, DVD, CD, CABLE, VCR, TAPE, AUX1 or AUX2.
2)
Once the input is selected, pressing the INPUT MODE key scrolls through the supported audio
modes (Analog, Coaxial, or Optical).
Front Panel Control:
To Select an Input
1)
Press FUNCTION knob in and dial until the display shows INPUT SELECT.
2)
Push FUNCTION to enter the INPUT SELECT sub-menu. You can rotate the knob in either
direction to scroll between all 8 inputs.
3)
Once you have dialed to your chosen input, pressing the FUNCTION knob again shows the audio
input mode. Each time the FUNCTION knob is pressed it cycles through the available audio
input modes (Analog, Coaxial, or Optical) for the selected input.
4)
Push FUNCTION in the RETURN position to return to the INPUT SELECT menu. Then rotate
the FUNCTION
knob to scroll through the other sub-menus.
5)
Rotating the Volume knob while in a sub-menu will return you to your last selected input and
