18
6.2 Sterilising
Before sterilising, clean as described in “6.1
Cleaning”.
Caution!
In order to prevent damage, follow
the manufacturer's instructions when using
any sterilisers or sterilising solution.
1. Always dismantle the components before
boiling or steam-sterilising (temperature
above 80 °C) and leave them dismantled,
otherwise deformation may result.
2. Boil the parts for 5 minutes in a pan of
vigorously boiling water.
Ensure there is sufficient water in the pan
to avoid damage.
3. The sterilised components must be
thoroughly cooled down and
completely dry
before being
reassembled and used again.
Notes:
• Use a NUK Steam Steriliser. Follow the
operating instructions associated with
the device.
• For sterilisation in a microwave oven we
recommend using the NUK Microwave
Steriliser (please follow the
manufacturer’s instructions for the
steriliser and the microwave oven!).
7. Reassembling the pump
(Figures
I
to
P
)
1. Insert the pump rod
in the pump
diaphragm
. The lower end of the pump
rod
must fit in the hole of the pump
diaphragm
. (Fig.
I
).
2. Position the pump diaphragm
in the
and press firmly in place
(Fig.
J
).
3. Insert the head of the pump rod
in the
pump lever
(Fig.
K
).
in the catch
(Fig.
L
).
5. Insert the lip valve
into the breast
shield
(Fig.
M
).
6. Screw the breast pump adapter
onto
the breast shield
(Fig.
N
).
7. Screw the breast milk container
onto
the breast pump adapter
with breast
shield
(Fig.
O
).
8. Position the silicone cushion
in the front
of the breast shield
and pull the edge of
the cushion over the breast shield
(Fig.
P
).
8. Using the breast pump
8.1 Expressing milk
Warning!
As hygiene is so
important, please wash your hands
before expressing your milk, and
read the information in “9. Storing
milk” on page 19.
1. Place the funnel of the breast shield over
your breast.
– Make sure that your nipple is in the
centre of the silicone cushion
prevents the nipple becoming sore.
– Gently press the breast shield
against
the breast so that the silicone cushion
fits closely and no air is sucked in
from the side.
–
Always
hold the breast milk container
with the adapter and breast pump
upright
.
then slowly
release.
Note:
The further you press the pump
lever
, the greater the suction. To reduce
the suction, do not press the pump lever
as far.
Please pay attention to the information
in “10. Tips for successful expressing”.
Caution!
• To achieve optimum results, express only
enough milk into the container so that it
Summary of Contents for 10.252.133
