24
G
B
– plug the vehicle adapter
into the
12 V power socket of the vehicle.
7. Briefly push down the start button
until the
indicator lamp
comes on (see Fig. D).
Now, the device starts vaporising the water
to heat up the baby food. As soon as all
water has been vaporised the device
switches off automatically and the indicator
lamp
goes out.
Note:
The device cannot be switched off
using the start button
. The device can only
be switched off prematurely by pulling out
the plug.
8. Remove the bottle or jar by using the
basket
Note:
– If the baby food is not hot enough, put a
little more water in the NUK bottle warmer
the next time you heat up food.
– If the baby food is too hot, put a little less
water in the NUK bottle warmer the next
time you heat up food.
– In "Car" mode, you need to allow much
longer heating-up times due to the lower
heating output (100 W).
9.
After heating:
Stir the content of the jar or
lightly rotate the bottle. Before feeding your
child, check on the inside of your wrist
whether the temperature of the food is safe
for your baby. A sensible temperature is
around 37 °C, which is the same as your own
body temperature.
10. To turn the device off, push
in the "OFF"
position.
11. Disconnect the device from the power
supply after use.
12. Allow the device to cool down for at least 15
minutes before its next use.
5.3 Switching the device off early
The device can only be switched off prematurely
by pulling out the plug.
Note:
After pulling out the plug the device is
without power but is still in heating mode. If you
put the plug back into a socket the device will
heat again until all water has vaporised. It is not
a defect if the indicator lamp 1 is alight when the
device is switched on. Fill some water in the
tank and leave the device switched on until the
water has vaporised and the automatic switches
the device off.
5.4 Overheating cut-out
The device also has an overheating cut-out to
rule out the risk of fire in the event of
overheating. If it trips, this device can only be
replaced by a specialist or by the manufacturer.
Contact the relevant service address (see
"Contact addresses" on page 130) for this
purpose.
