233936 Page 28 04/12 (A02)
Removing the dome and waste-water tank.
To remove the dome, unclip the locking toggles and lift the
dome off the machine (Fig 14).
The waste water tank is held into place with a red locking clamp.
Undo the clamp (Fig 15) and lift the waste water tank from the
machine (Fig 16).
Fig 14
Fig 15
Fig 16
Filling the NuChem / Water Tank.
The NHL 15 is equipped with a large 15 litre clean-water tank allowing large areas to be cleaned in a single fill.
To fill the NuChem / water tank remove the waste water tank and fill using hose, bucket or a suitable container (Fig 17).
Fill to the MAX level mark (Fig 18) located on the inside of the drum.
Ensure the clean water goes into the container and not the central tube.
Note.
Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc) are not allowed to enter the clean-water during the
filling process.
If using a bucket or similar container, ensure it is always clean and free from debris.
Caution:-
Avoid tipping water into the central tube this is leads directly to the vacuum motor (Fig 19).
Fig 17
Fig 19
Fig 18
