background image

9

T 01460 269401

Information for 

Wet & Dry Use Vacuum Cleaners

Read the instruction manual before using the machine.

Operators shall be adequately instructed on the use of these machines.

As with all electrical equipment, care and attention must be exercised at all times during use, in 

addition to ensuring that routine and preventative maintenance is carried out periodically to ensure 

safe operation. 

Failure to carry out maintenance as necessary, including the replacement of parts to the correct standard 

could render this equipment unsafe and the manufacturer can accept no responsibility in this respect.

The machine shall be disconnected from the mains by removing the plug from the supply socket during 

cleaning or maintenance and when replacing parts or converting the machine to another function.

The machine is not to be used by children or persons with reduced physical, sensory or mental capabilities, or 

lack of experience or knowledge, unless they have been given supervision or instruction.

Children being supervised are NOT to play with the machine.

This appliance is intended to be assembled, cleaned and maintained by an adult.

This machine is not a toy.

WARNING

CAUTION

DO

DON’T

ORIGINAL INSTRUCTIONS

READ MANUAL BEFORE USE

If foam/liquid comes out of machine exhaust, switch off immediately.  Allow the accumulated liquid 

to drain out through the machine exhaust, check the float assembly to ensure correct operation, 

empty the container if full of liquid, reassemble the machine. Immediately upon start up there will 

be a certain amount of liquid issuing from the machine exhaust which will be the residue of liquid 

still within the power head. This will be quickly discharged after which the machine should function 

normally. 

Liquid ejected from the machine could be hazardous as a result of its temperature, pressure or chemical 

content.  

This machine is not suitable for the collection of biological hazards, hazardous or explosive dust. 

You should contact your local distributor if you require a machine capable of performing these tasks. 

Ensure that the filtration system fitted to the machine is suitable for the material being collected.

This machine is for indoor use only.

This machine shall be stored indoors only

This product complies with the requirements IEC 60335 -2.69.

NOTES

 This machine is also suitable for commercial use, for example in hotels, schools, hospitals, factories, 

shops and offices for other than normal housekeeping purposes.

This machine can be used for wet and dry pick up.

  •  

Keep your machine clean.

  •  

Keep filters clean.

•  

Regularly clean the water level limiting float safety valve and examine for signs of 

 

damage or correct operation.

•  

Keep hoses clear.

•  

Replace any worn or damaged parts immediately.

•  

Regularly examine the power cord, if damage is found, power cord must be replaced by a    

 

qualified person using the correct Numatic original part.

•  

Empty dust container frequently.

•  

Keep diffuser filter (where fitted) clean.

• 

Dispose of waste in an enviromentally responsible way.

•  

Use steam cleaners or pressure washers to clean the machine or use the machine in  

 

 

the rain.

•  

Immerse in water for cleaning.

•  

Allow any inexperienced repairs. Call the experts.

•  

Use wet if float valve is not functioning or fitted.

•  

Use to suck up hot ashes, or lighted cigarette ends.

•  

Run the machine over the power cable during operation as a hazard may occur.

•  

Pull on the cable to unplug the machine from the power supply.

•  

Walk over-wet carpets, upholstery or fabrics.

•  

Walk on clean carpets until fully dry.

•  

Spray onto people or animals.

•  

Attempt machine maintenance or cleaning unless the power supply plus has been removed from the  

 

supply outlet.

Summary of Contents for SSIVD 1800 AP













Reviews: