7
T 01460 68600
The vacuum hose has a U-bend clip which creates a U-bend in the hose preventing water spillage when the vacuum is switched
off. If you need to remove the U-bend clip for any reason always ensure it is refitted correctly before you resume operation.
Fitting the Hose Guide
NOTE: DO NOT push the vacuum hose
onto the floor tool with the floor tool in
the raised position.
Machine Set-up Guide
Refit vacuum hose to the
Floor tool when finished.
250mm - 300mm
NOTE: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not allowed to enter the clean water
tank during the filling process. If using a bucket or similar, ensure it is always clean and free from debris.
The TGB 6055/100 is equipped with a large capacity clean water tank allowing for large areas to be covered in a single fill.
Filling the Clean Water Tank
10
To fill the clean water tank, extend the hose located to the rear of the machine in the centre of the removable filler cap
(1)
. Pull out
hose. Open the stopper and place hose under water tap, or use a hose to commence filling. The tank can also be filled by unscrewing
the filler cap and using a bucket or similar container
(2)
.
1
2
Summary of Contents for TGB 6055/100
Page 24: ...24 T 01460 68600 EU Declaration of Conformity...
Page 25: ...25 T 01460 68600 Warranty...
Page 26: ...26 T 01460 68600 Notes...
Page 27: ...27 T 01460 68600 Notes...
