11
T (+ 44) 01460 68600
To operate, select forward and depress the accelerator pedal.
Vacuum pick-up and water flow will turn on if selected, and providing the brush and floor
tool are in the lowered position, the machine will move forward.
Clean water is dispersed evenly via ‘THRU- FEED’ scrubbing brushes.
The waste water is then retrieved by the suction floor tool.
Overlap each scrubbing path by 10cm to ensure an even clean.
After stopping, let the vacuum motor run for 10 seconds to collect any water left in the
vacuum hose, then switch the vacuum motor off.
On heavily soiled floors use a ‘double scrub’ technique.
First pre-scrub the floor with the floor tool in the raised position, allow the chemicals time
to work, then scrub the area a second time with the floor tool lowered.
If your machine leaves streaks on the cleaned floor, either clean the floor tool blade or
adjust blade height for optimum performance.
Machine operation
Machine in use
DO NOT OPERATE THE MACHINE ON INCLINES THAT EXCEED 11%.
!
!
The optional off-aisle cleaning kit gives added flexibility to the operator.
The kit can be used to clean hard to reach / inaccessible areas.
Remove the vacuum hose from the floor tool and attach to the off-aisle kit.
To operate the vacuum, press the vacuum switch on.
NOTE: Return the hose to the floor tool
once finished using the off-aisle facility.
Off-aisle cleaning kit (optional extra accessory) 606182
Adjusting the blade height.
Set lever to forward.
Water flow rate selection.
Brush deck in lowered position.
Low
High
Floor tool lever in lowered position.
Off-aisle vacuum switch.
Low
High
HEAVY
SO
ILIN
G
NOTE: MACHINE WILL NOT REVERSE WITH
FLOOR TOOL IN THE LOWERED POSITION.
!
!
