Machine Set-up Guide
9
T 01460 68600
The machine is now ready to be driven to the cleaning site.
Before performing the cleaning operation, place out appropriate warning signs and sweep or dust-mop the floor.
Use the maximum speed control knob and set desired
traction speed as required, depending on floor type and level
of soiling.
Middle speed is the optimum cleaning speed for most types
of floors.
Once the Max speed has been set using the control knob on
the control panel, fine adjustments can be made using the
variable control speed pedal located on the right side of the
footplate.
Maximum Speed Control
Emergency Stop Button and Horn
The TRO 650 / 200T is equipped with an electronic braking system.
Simply lift your foot from the accelerator and the machine will stop.
In an emergency, strike the emergency-stop isolator button
The machine will be disabled.
To reset, turn isolator button clockwise
(see Fig.21)
.
After resetting the emergency stop button, to restart the
machine, turn the ignition key to (0) ‘OFF’ then to position
(1) ‘ON’ again.
The horn is located on the right-hand side of the operator control
panel
(see Fig.22).
21
22
Sitting in the driving position, adjust
the seat forwards or backwards as
necessary by using the lever found on
the left-hand side (see Fig.23).
Note: The seat is fitted with a
pressure sensor that disables the
machine until an operator is seated.
Adjusting the Seat
IMPORTANT
Do not operate machine unless the Operator Manual has been read and fully understood.
!
!
Summary of Contents for TRO 650/200T
