MODEL: SPS08
RECOMMENDED HOOKUP
QUICK
QUICK
CONNECTION
CONNECTION
�p�up����
REGULATOR
LUBRICANT
FILTER
HOSE
UNIT
UNIT
REGULATOR
COMPRESSOR
TROUBLESHOOTING
08
A
WARNING:
Stop using tool immediately if any of the following problems occur. Serious personal
injury could result. Any repairs or replacements must be done by a qualified service
person or an authorized service center.
MODEL: SPS08
PROBLEMS
Gun does not spray
Material sags or runs
POSSIBLE CAUSE(S)
CORRECTIVE ACTION
1. Air hose connections at
1. Tighten and seal hose
compressor are loose.
fittings with Teflon tape if
2. Paint cup is loose.
leaks are found.
3. Fluid tube, fluid tip or air caps 2. Tighten paint cup to gun.
loose, clogged or damaged.
3. Clean parts with solvent.
4. Air pressure too low.
4. Adjust regulated air
5. Material is too thick or needs
pressure to 40-55 PSI.
straining.
5. Thin material according to
6. Fluid control knob closed.
manufacturer's
instructions and strain
material using a paint
strainer.
6. Adjust fluid control knob.
1. Material improperly thinned. 1. Thin material according to
2. Movement of gun is too slow.
manufacturer's instructions.
3. Gun held too close to work
2. Move at a moderate pace,
surface.
parallel to surface.
3. Keep the gun 6 to 9 inches
from the work surface.
09
